|
REAR COIL SPRING SPACER INSTALLATION INFORMATION - WITH ALIGNMENT RIDGE. Part No. BE-5511-R 1965 - 1978 Ford/Mercury RWD Products 1977 - 1979 Ford Thunderbird Part No. BE-5510-R 1979 - 1997 Ford/Mercury RWD Products Click On All Pictures To Enlarge |
||
|
STEP 1: Remove the coil spring and rubber insulator if there is still one there and clean around the alignment ridge with a wire brush. . |
||
|
|
||
|
STEP 2: Mount the spacer over the alignment ridge making sure it is down flat and solid on the platform .The new spacer has a higher alignment ridge than the original ,so now is the time to put on the old rubber insulators, if they were ok to reuse. If you do not want to reuse them, just leave them off. DO NOT USE ONLY ONE SIDE AS THIS WILL CHANGE HEIGHT ADJUSTMENTS. |
||
|
|
||
|
Step 3: This is what it will look like when the spacer and coil have been re-installed. Our spacers will work on almost any rear wheel drive vehicle. |
||
|
|
||
|
NOTE: Your rear end housing may not look exactly as shown, but the installation information is the same. Budzter's coil spring spacers will lift your coil springs up 1 full inch and maybe slightly more because it compresses the spring (possibliy 1/8 to 1/2 inch more). ALWAYS USE ALL SAFETY PRECAUTIONS! We are not responsible for any accidents, or injuries, or damage, caused by the installation or use of Budzter Coil Spring Adjusters or Spacers. Click here to Order Spacers |
||
|
© 2000 - 2008 ALL IMAGES AND DESIGNS ARE PROPERTY OF BUDZTER ENTERPRISES® |
||
