|
REAR COIL SPRING SPACER INSTALLATION INFORMATION - WITH ALIGNMENT RIDGE. Part No. BE-5510-R 1979 - 2004 Ford Mustangs 1980 - 1988 Ford T-Birds, Mercury Cougar Click On All Pictures To Enlarge |
||
|
STEP 1: Remove the coil and the rubber insulator (it may be missing by now) and clean around the alignment ridge with a wire brush. It needs to be clean and level around the base of the alignment ridge so the spacer will sit flat and all the way down over old alignment ridge. |
||
|
|
||
|
STEP 2: Put spacer on over old alignment ridge and make sure it is down all the way and sitting level.Now you can put old or new rubber insulator on TOP of the spacer as we have a higher alignment ridge on the new spacer. If you choose not to put a rubber insulator back on , this does not seem to be a problem. No one has called us to say they had a problem with more noise, but obviously this is your choice. DO NOT PUT ANY ON IF YOU DO NOT HAVE ONE FOR EACH SIDE. This could change height on one side. |
||
|
|
||
|
Step 3: This is what it will look like when you are done,and ready to put back together. |
||
|
|
||
|
Budzter's coil spring spacers will lift your coil springs up 1 full inch and maybe slightly more because it compresses the spring (possibly 1/8 to 1/2 inch more). ALWAYS USE ALL SAFETY PRECAUTIONS! We are not responsible for any accidents, or injuries, or damage, caused by the installation or use of Budzter Coil Spring Adjusters or Spacers. Click here to Order Spacers |
||
|
© 2000 - 2008 ALL IMAGES AND DESIGNS ARE PROPERTY OF BUDZTER ENTERPRISES® |
||
