STEP 1: This is a Mustang lower control arm, but all Fox body cars are the same. Remove the coil spring and the rubber insulators if they are still there and wire brush around the alignment ridge.

STEP 2: Next put the shim over the alignment ridge. Turn the holes in line with the control arm and drill two 3/8 holes .

Step 3: Put the shim on and then the adjuster and bolt them down using the grade 8 bolts and lock nuts supplied. The grade 8 bolts and lock nuts are hard to turn, but it is worth the effort for safety. Now turn the adjusters down to the bottom until they are in the car. This is what they will look like when you are ready to put it in the car. After they are installed in the car you can adjust them accordingly.

Budzter's coil spring adjusters will give you almost as much traction as ladder bars or a four link with small slicks when set up properly. This will drop your 60 foot times drastically.

ALWAYS USE ALL SAFETY PRECAUTIONS! We are not responsible for any accidents, or injuries, or   damage, caused by the installation or use of Budzter Coil Spring Adjusters or Spacers.

Click here to Order Adjusters